48Gbps 8K HDMI over HDBaseT Extender Kit (150m/492ft) New

Most HDMI extenders cap out at 4K and 70-100m - leaving integrators without a viable single-cable solution for long-run 8K deployments or large-venue 4K installations that push past the 100m barrier. The KanexPro EXT-HD8K-150M closes that gap by extending HDMI 2.1 signals up to 150 meters over a single CAT6 cable, delivering 8K@30Hz at 40m, 4K60 4:2:0 at 100m, and full 1080p at 150m - all without active optical cables or signal repeaters.

The TX/RX kit ships with everything an integrator needs: bi-directional IR, RS-232, analog stereo audio de-embedding on both TX and RX, 24V PoC, and a 7-mode DIP-switch EDID manager. HDCP 2.3, HDR10, HDR10+, Dolby Vision, and HLG supported end-to-end.

• Extends HDMI 2.1 (48Gbps) signals up to 150m/492ft over a single CAT6 cable — 8K@30Hz at 40m, 4K60 4:2:0 at 100m, 1080p@60Hz at 150m
• HDMI 2.1 input on TX accepts 8K, 4K, and 1080p sources — HDMI 2.0 output on RX delivers to any compatible display
• HDCP 2.3 compliant with full HDR support — HDR10, HDR10+, Dolby Vision, and HLG pass-through end-to-end
• Bi-directional IR pass-through (20–60kHz) enables remote control of source and display from either end of the cable run
• RS-232 pass-through via 3-pin phoenix connector on both TX and RX for third-party control system integration
• Analog stereo audio de-embedding (L+R phoenix) on both TX and RX — local speaker feed without a separate audio extractor
• 24V Power over CAT6 (PoC) — power the RX from the TX over the same CAT6 cable, reducing power outlet requirements at the display end
• 7-mode DIP-switch EDID manager (1080p, 4K30, 4K60 × 2CH/7.1CH + sink copy) — no software required for setup
• Locking HDMI connector on TX prevents accidental disconnection in rack or behind-wall installations